The Emerson that I have been working on needs some sort of belting. I used
1/8 inch square drive material but it is too thick and binds when the dial
scale support is mounted.

Did they use a leather belt on the original?

Where can I get some flat 1/8 inch wide belting material?

Here is the picture of my failure.
http://www.ppinyot.com/E/emerson/IMG_6235.JPG

Radio page: http://www.ppinyot.com/emerson.htm

Thanks guys and gals,

Paul P.

Listed replacements for your radio are:

G-C Belt 156 7 9/32" ID (7.281")
JFD Belt 56 Same ID

Adams Radio lists the dial belt for an Emerson AP, many people have bought belts there. adamsradio.com
Don

Adams Manufacturing. Great place. I did not know of it. I ordered the belt.

Thanks all,

Paul