Since the Pioneer Days of Radio
THE GIANT PUNCH PRESSES
Tons of pressure applied to a sheet of steel by means of these presses results in a completely stampled Remler Radio chassis in a single operation. Uniformity in manufacturing is assured by means of these presses. Every Remler is identical in construction.
THE TOOL AND DIE DIVISION
Dies accurate to one ten-thousandth fraction of an inch for precision manufacturing requirements are made right here in the Remler plact. The Remler product is built like a fine watch. Even the tools used in building Remler Radio are made in our own factory.
AUTOMATIC SCREW MACHINERY
The hundreds of finely threaded screws amd nuts, washers and seperators, are made from the raw metal by means of these automatic screw machines. Threading, drilling, knurling, finishing and cutting are all accomplished in a few operations. A half million small fittings per day is the output of this department of the Remler factory.
BAKELITE MOULDING PRESSES
Our own completely equipped Bakelite moulding plant makes it possible to supply Bakelite fittings on all Remler Receivers at a nominal cost instead of cheaper and inferior substitute materials usually employed on radio sets.
Back to Antique Radios.